[scramblinman]

Anyone know the factory torque spec for both frame/engine sliders and rear swingarm sliders?

 

[scramblinman]

Bump

 

[Asiaoildude]

Probably a 1/4 turn after finger tight.

 

[scramblinman]

The frame sliders support the engine, there has to be a spec for that?

 

[stavely]

Isn't it frustrating that this sort of info is not supplied in the manual supplied with the bike.
I wonder if its in this one.......
All Motorcycle Service Manuals Resource: 2015 DUCATI SCRAMBLER Workshop Manual

 

[DirtyDuc]

Probably a 1/4 turn after finger tight.

This should be ok.

But usually for any swing arm spools (6mm or 8mm) I usually torque them down to 9ft lbs and no more than 12Ft lbs max. ive been using this spec for all my bikes when installing spools/bobbins. for extra security i'd use some blue loctite just in case.

 

[ammiraglio]

I've the service manual, but cannot understand what you are referring to talking about "sliders".

On the manual sliders are those to tension the chain. If you can clarify, I'll look into the manual.

 

[ragtop]

 

[scramblinman]

I was able to get an older copy of instructions from speedymoto for the monster and it gave a torque spec of 37ftlbs for the initial nut and 18ftlb for the slider, so I went with that.

 

[vudiesel]

60 NM is 44FT LB correct? Doesn't that sound a lot?