Ducati Scrambler Forum banner
1 - 9 of 9 Posts

·
Scrambler DIY Guru
Joined
·
979 Posts
I have this Condor aluminum wheel chock. It's universal, so in some ways less useful than a paddock stand. But also, I can use it for any motorcycle. I love having it because I can chock either the front or rear wheel and jack up the opposite end to service the bike.

It's very heavy duty and built to hold goldwings and harleys securely, so it'll hold a 400 pound bike no problem.



Sorry, if this isn't what you're looking for. Just wanted to share that it has been really useful in my garage for me.
 

·
Registered
Joined
·
1,104 Posts
The plate is attached to the stand not the bike. Will post pictures soon ;)
Ok sounds good though having downloaded instructions it looks like a frame bolt gets swapped out. I will have Evotech crash bungs so am interested to see exactly what needs doing to bike if anything to allow the stand to operate. Looks quality bit of kit so looking forward on your thoughts :)
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top