[rulle_retard]

Just finished my own license plate holder to get rid of the butt ugly original one. Also changed the turn signals to LED ones, what a difference! The good thing about the scrambler is that it is super easy to change the turn signals cause you doesnt need any new relay or resistors!

I also changed to a FT-handlebar which I think makes a huge difference to the handling, nicer riding position. My goal is to make the bike so "stripped" as possible by get rid of parts that I doesnt really need or replace them by smaller ones.

I will post more pictures of the "whole" bike sometime soon

 

[TC3]

Nice is it difficult changing the front indies? I think I read the front leads run under the tank?

 

[rulle_retard]

Nice is it difficult changing the front indies? I think I read the front leads run under the tank?

No, super easy. But depends on how you want to do it. The connectors to the original ones is seated under the right side of the tank, not hard to reach. Just unscrew the tank and lift it slightly to the left.

But I didnt bother to keep the original ones, will never put them back again! So I just cut the wires right after the original turn signal (got all the cable left, all the way back to the original connector) and used water sealed butt connectors to connect the LED ones, took about 1 hour to do all four.

 

[Hedonism]

are the new ones by Rizoma? (club)

 

[TC3]

Thanks for the info

 

[Todd Abbott]

Looks nice! What do you have for the bar end mirror? Also, is that electrical tape on the headlight?

 

[rulle_retard]

are the new ones by Rizoma? (club)

No, they are from a chain store here in sweden. You can compare them to like Ikea but with car parts, motorcycle parts and a lot of other stuff. They only sell their own brand to very good prices. Unfortunately they dont have any online business at all

 

[rulle_retard]

Looks nice! What do you have for the bar end mirror? Also, is that electrical tape on the headlight?

Thanks! The bar end mirror comes from the same store that I explained in the post above, looks like this: Backspeglar styrände - Backspegel MC-tillbehör - Biltema

And yes, it is electrical tape on the headlight

 

[MNT250]

Wow, that turned out amazing. Great job! Could you snap a photo of how the signals mounted on the front? I've been looking at universal signal options but it seems like the bolt diameter on them would be too large to fit in the stock hole.

 

[rulle_retard]

Wow, that turned out amazing. Great job! Could you snap a photo of how the signals mounted on the front? I've been looking at universal signal options but it seems like the bolt diameter on them would be too large to fit in the stock hole.

Thanks!
I fitted the signals i the small hole, behind the large one where the original sits Fits perfect for M6!

 

[divaha]

Just finished my own license plate holder)

Looking great. Do you have more information or picture how you did mount and create the plate holder? Thanks for sharing.