Ducati Scrambler Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,104 Posts
Discussion Starter · #1 ·
Those of you with a UK 8X6 plate on your bike, I know the holder needs to be trimmed at the bottom if you use an 8X6 plate but what about a 7x6 plate? Ok I could use a 7X5.5 and cut a bit more off at bottom but was wondering on the width of the plate holder. Would it need trimming if you use a plate 7 inch wide?

I was able to choose a reg today though no news on bike yet. Just want to get a plate made as have no control over the build time and I need some control ;)
 

·
Registered
Joined
·
1,104 Posts
Discussion Starter · #2 ·
Ok so could someone please measure the distance between the edge to edge of the plate holder as indicated on red line. I have imported a bunch of plate sizes in Cad software and want to get bike size right as i import it and then see what plates look like on bike

 

·
Premium Member
Joined
·
370 Posts
Ok so could someone please measure the distance between the edge to edge of the plate holder as indicated on red line. I have imported a bunch of plate sizes in Cad software and want to get bike size right as i import it and then see what plates look like on bike

Tony its 175mm edge to edge with a standard tape measure.:D
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top