[Hedonism]

are they m6 or m8?

 

[Hedonism]

since I really need this info, I asked to the dealer to check the demo bike.

the 4 bolts clamping the handlebar are 8m while the 2 holding the "riser" are 10m

in case somebody needs to buy some risers, the handlebar is 22mm fixed diameter

 

[murathanoz]

since I really need this info, I asked to the dealer to check the demo bike.

the 4 bolts clamping the handlebar are 8m while the 2 holding the "riser" are 10m

in case somebody needs to buy some risers, the handlebar is 22mm fixed diameter

İs there any lower handlebar that does not force us to change the risers and fits the original unit?

 

[Hedonism]

any 22mm diameter handle bar will fit the original "cramping risers"

 

[Stu]

Hedo,

I just posted this elsewhere:

Contour | Pro Taper

They have a great variety of shapes available with different heights. Other manufacturers may as well. The Contour bar is 1 1/8" at the clamp so it should work with the 22mm on the Scrambler.

Stu

 

[Hedonism]

uhm.... I think 1 inch is 25mm and 1 1/8 (i.e.1,125 inches) is 28 mm

even in pictures, the clamping area looks to be bigger than the end of the handlebar.

 

[Derek]

Handle bars are generally 7/8" (22mm) except for Harleys and some old Triumphs that were 1"(25mm).
Taper bars are usually 1 1/8" (28mm) at the clamps, tapering to 7/8" (22mm) at the grips.

 

[murathanoz]

Handle bars are generally 7/8" (22mm) except for Harleys and some old Triumphs that were 1"(25mm).
Taper bars are usually 1 1/8" (28mm) at the clamps, tapering to 7/8" (22mm) at the grips.

So is Scrambler has a taper bar or not?

clamping diameter(1-1/8" | 28.6mm) to be larger than the control ends (7/8" | 22.2mm).

Will this one fit ?

 

[Derek]

So is Scrambler has a taper bar or not?

clamping diameter(1-1/8" | 28.6mm) to be larger than the control ends (7/8" | 22.2mm).

Will this one fit ?

Well the Full Throttle handlebar is described as "Variable Section". So I'd reckon that it's tapered.

 

[murathanoz]

Well the Full Throttle handlebar is described as "Variable Section". So I'd reckon that it's tapered.

Yes i think it is.

Here another site says;
It tapers down to 7/8" diameter at its ends to accommodate grips and controls.

Ducati Scrambler Aluminum Tapered Handlebar: 96280181A

 

[Hedonism]

the Icon, has 22mm, on the clamping area as well as near grips, I've used the gauge on it to check value

 

[murathanoz]

the Icon, has 22mm, on the clamping area as well as near grips, I've used the gauge on it to check value

Maybe it is suitable for a ticker bar becuase i can see some gap around the bar?

 

[murathanoz]

https://www.youtube.com/watch?v=uSZ62AwOhoA

Full Throttle has definetely tapered handle bar, and also it has the same clamp with icon however there is a visible gap between clamp.
Check out 1:37