Ducati Scrambler Forum banner

Custom grab rail block off plates

3850 Views 4 Replies 4 Participants Last post by  MJ83
Since installing my Zard low mount I decided to carry the speed hole theme to other parts of the bike to help unify the look. The 1/16" aluminum panels are curved to match the fender contour and allow full use of the grab handle. It all goes together like a jigsaw puzzle and needs no additional mounting hardware. I think it ties in nicely with the aluminum tank panels as they are connected with the silver strip that runs under the seat. I also love how the holes run at a similar angle with those on the exhaust. Now I'm debating on whether or not to making the holes larger or if it looks fine as is. What do you guy's think?


See less See more
  • Like
Reactions: 3
1 - 1 of 5 Posts
That looks really sharp! You know though, that heat shield on the rear pipe is begging for the same treatment now. :)
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.