Ducati Scrambler Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
473 Posts
there is a "plate" to be placed on the bike, on the frame I suppose, to this plate, you will plug the tower, in this way you can use it for several bikes, each of them must have its own plate fitted


Inviato da mio iPad utilizzando Tapatalk
 

·
Registered
Joined
·
168 Posts
I liked the Bike Tower not only for maintenance but also for being able to move the bike in the garden or the garage (tight turns, corners etc).

The stand itself looks good and feels sturdy



The only thing you need to do to the bike is remove one framebolt and exchange the nut for a threaded cylindre (in the picture above it is still attached to the plate). You have to insert the bolt the other way around because the nut was on the other side. The addition to the bike is minimal in my opinion. If you didn't know it was there, I don't think you would notice it.



You have to lift the bikestand to insert the pins, but once you get the hang of it, it is quite easy. I had to make some adjustments to the plate but now that everything lines up, I don't have to touch it again.




Job done ;)
 

·
Registered
Joined
·
248 Posts
Anyone looking for these types of Stands in the US or Canada, I've purchased from MOTOMFG.COM before and their stand for the Diavel is awesome. Don't know if they have one for the Scrambler yet...
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top